Fiamma MARINA Manuel D'instructions page 9

Check the machine manometer to see if the boiler pressure is at +/- 1 bar.
The pressure in the boiler can be adjusted by regulating the machine pressure gauge.
Now you can begin to make coffee.
The machine has filters for one or two coffees and all you need to do is select the required filter,
put it in the group with the correct dose of coffee (5,5 to 6,5gr. per coffee) switch the group on
and then switch it off when you have the required amount of coffee.
In order for it to work properly, you should check the coffee grind.
If the outlet time is longer then 20/25 seconds, you should adjust the grinder for a thicker grind
and vice-versa if the length of time is shorter.
NOTE: It is better to maintain the filter holder clean and placed in the group (even when you're
not going to make coffee) in order to maintain the filter holder warm and have a good
quality coffee.
When placing the ground coffee in the filter, press it in a uniform way.
The machine is ready, you can start making coffee.
VOLUMETRIC CONTROL MODELS (C.V.)
The C.V. models are different from the other ones because it is possible to pre-program coffee
doses, seeing as the machine switches off automatically when it reaches the programmed dose.
Programming mode: please refer to supplement
HOW TO OPERATE THE MODELS WITH INTERIOR TANK
In case of models with an interior tank (versions "DI"), first fill the tank with water before
operating the machine. To fill the tank, take off the chromed cover plate at the top of the
machine and fill the tank with water. When the tank is full, switch on the main switch (
green signal lamp will turn on to indicate that the boiler is being filled. Once the water reaches
the predefined level, the pump stops and the green signal lamp switches itself automatically off.
Once the boiler is filled, turn on the heating switch. An orange signal lamp will turn on. The
machine starts to heat up and when the working temperature is reached, the orange signal lamp
switches itself automatically off.
A level sensor (situated on the outside of the tank) controls the water level in the tank. Once the
water reaches the minimum level, the sensor automatically blocks the control display and the LED
signal lamps will start to flash. The control display will only start to function again when the tank
has been refilled with water.
A drain tank for residual water is situated on the lower part of the machine. This drain tank should
only be used in case it is not possible to establish a connection to the sewage.
NOTE: The drain tank has to be completely cleaned after each work day.
All manuals and user guides at all-guides.com
"MARINA CV DI"
0/I
). A
GB
9