Fiamma MARINA Manuel D'instructions page 24

2. DOSAGE DEFINITION
In order to define the amount of coffee per dose, please proceed as follows:
1.
Insert the desired dose(s) of coffee in the filter-holder and set it into the group.
2.
Press the configuration key KCONT and keep pressing for 5 seconds.
This will turn on all the LED signal lamps.
3.
Within the following 20 seconds, press any of the start/stop keys
(for example: K1EXP). This will light up the associated LED signal
lamp (i.e. L1EXP). Also, the LED attributed to the confirmation
mode (LCONT) will light up. All other LED's will switch
themselves off.
4.
When the desired coffee dose is reached, press the start/stop key for
the respective dosage (i.e. K1EXP). Now, the associated LED signal
lamp will switch itself off and all others will light up.
To define the other dosages, repeat the same operation.
In order to leave the configuration mode, wait for 20 seconds.
3. WASHING THE GROUP
In order to clean the group with the washing function, please proceed as follows:
- Put the blind filter into the filter-holder and fill it with a tea spoon of an adequate detergent for coffee
machines. Put the filter-holder into the group.
- Make sure the machine is turned off. Press and hold the key K2EXP,
which will turn on the machine. Check whether the LED signal lamps
L1LUN and L2EXP are blinking to indicate that the washing process
has been initialized.
The washing process consists of 5 washing cycles.
Once the washing is finished, the system will automatically set itself to the ON position.
NOTE: It is not possible to interrupt the washing process. Therefore, you have to wait for the washing to finish
before you can prepare coffee again.
All manuals and user guides at all-guides.com
5