Washing Programmes; Turning On The Appliance; Change The Program - Samsung DW60H3010FV Manuel D'utilisation

Washing programmes

TURNING ON THE APPLIANCE

Starting a cycle wash
1. Draw out the lower and upper basket, load the dishes and push them back..
It is recommended to load the lower basket fi rst, then the upper one (see the section entitled "Loading
the dishwasher racks").
2. Pour in the detergent (see the section entitled "Using the detergent and water softener").
3. Insert the plug into the socket. The power supply is 220-240 V~, 50 Hz, the specifi cation of the socket
is 15A 250 VAC. Make sure that the water supply is turned on to proper pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Press the Program button, the wash program will be changed as follows direction:
ECO  Express  Quick Wash  Delicate  Pre Wash  Intensive  Auto
DW60H6050
ECO  Express  Delicate  Pre Wash  Intensive  Auto
DW60H5050
ECO  Express  Intensive
DW60H3010
If a wash program is selected, the response light will light. Then press the Start button, the dishwasher
begins to start.
When you press the Start button to pause during washing, the running indicator will stop blinking and
the dishwasher will beep every minute unless you press the Start button to start.

CHANGE THE PROGRAM...

Premise:
1. A cycle that is underway can only be modifi ed if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refi lled (see the section entitled "Fill the detergent in
dispenser").
2. Press the Startbutton, the machine will be in standby state, press the Program button more than 3
seconds then you can change the program to the desired cycle setting.
If you open the door during a wash cycle, the machine will pause. The program light will stop blinking
and the buzzer will beep every minute unless you close the door. After you close the door, the machine
will keep on working after 3 seconds automatically.
If your model has broken memory function, the machine will go on to finish the selected program after
the power cut.
Add a dish
A forgotten dish can be added at any time before the detergent dispenser opens.
1. Press the Start button and make sure to open the door slowly and carefully as there is a
possibility of injury from the hot steam inside the dishwasher.
2. After the spray arms stop working, you can open the door completely.
3. Add forgotten dishes.
4. Close the door. The dishwasher will work after 3 seconds.
WARNING: It is dangerous to open the door when washing, because the hot water may
scald you. If the door is opened while the dishwasher is running, a safety mechanism is
activated and stops the cycle.
34_ Washing programmes