Playing A Disc - Sony SCD-XA9000ES Mode D'emploi

Playing a Disc

The operations for normal play and the basic operations
during play are explained below.
POWER SACD/CD
i.LINK
1
Turn on the amplifier. Turn down the volume level
to the lowest.
2
Select the player position using the input selector
on the amplifier.
3
Press POWER to turn on the player.
4
Press A OPEN/CLOSE to open the disc tray, and
place a disc on the tray.
With the label side up
5
Press N.
Playback starts from the first track. If you want to start
playing from a specific track, turn . AMS > to
select the track number before pressing N.
6
Adjust the volume on the amplifier.
16
US
N X
A OPEN/CLOSE x
.AMS>
Basic operations during play
To
Stop play
Pause play
Resume play after pausing
Locate a succeeding track
Locate the beginning of the
current track or a preceding
track
Eject the disc
z
If you turn on the player when a disc is already loaded
Playback starts automatically. If you connect a commercially
available timer, you can set it to start playing the disc at any time
you want.
z
To select a layer you want to listen to when playing a hybrid
disc (page 15)
Press SACD/CD repeatedly to light either the "SACD" or "CD."
z
To select a playback area you want to listen to when playing
a 2 channel + Multi-channel Super Audio CD (page 15)
Press MULTI/2CH repeatedly to light either the "MULTI CH" or
"2 CH."
Notes
• During playback, increase the volume level gradually starting
from the lowest level. The output from this unit may contain
band width that are out of the normal listening range. This may
cause damage to the speakers or ears.
• When you change the playback area during the Program Play
mode, the program is cleared.
• When you change the playback area, the playback starts from
the beginning of the same track. However, the playback starts
from the first track depending on the disc.
To use the i.LINK function
You can output the sound through i.LINK S200 AUDIO
OUT jack and enjoy the high quality sound. Refer to the
Operating Instructions supplied with the connected
component.
Press i.LINK to turn on the i.LINK indicator.
To turn off the i.LINK function and listen to the analog
sound, press i.LINK again to turn off the i.LINK indicator.
Note
If you press N while the connected component is not ready for
the i.LINK function (ex., while "i.LINK Connecting" appears in
the display of STR-DA9000ES/TA-DA9000ES), the sound at the
beginning of the track may be dropped out.
When the i.LINK indicator is lit
• No signal is output from all the other jacks (ANALOG 2CH
OUT jacks, ANALOG 5.1CH OUT jacks, PHONES jack,
DIGITAL (CD) OUT jacks).
• The "D. FILTER", "D. OUTPUT", "2CH SPK MODE", "MCH
SPK MODE", "LEVEL ADJUST" and "SPK DISTANCE" menu
operations are not available.
Press
x
X
X or N
Turn . AMS > clockwise
Turn . AMS >
counterclockwise
A OPEN/CLOSE