General Maintenance - Rocky Mountain POWERPLAY Guide D'utilisation

20
Cable routing
NOTE: REMOVE DRIVE SIDE COVER AND LEFT SIDE HEAD TUBE PORT COVER. ALL
OTHER COMPONENTS CAN REMAIN IN PLACE.
• Route the derailleur housing through the chainstay near the main pivot, front to back
(fig 1)
• Route the other end up the right forward motor mount port to the left head tube port
• Clamp housing to motor mount using shift housing clamp (fig 3) and torque to 2Nm
fig 1
BOTTOM BRACKET STANDARD
The Powerplay Drive uses a Press Fit BB92.
NOTE:
• This allows a gap on the Race Face spindle for the Clutch Spider.
• USE THE CORRECT SPIDER FOR EITHER RACE FACE OR SRAM EAGLE
CHAINRINGS. THESE ARE THE ONLY APPROVED CHAINRINGS.
Powerplay Owner's Manual
fig 2 fig 3
Powerplay Owner's Manual

General maintenance

Please note that electric assist bikes put more stress and strain on components than
traditional mountain bikes. The frequency of maintenance and inspection should
increase in consequence, to maximize safety, performance, and longevity.
Seasonal charging
If you store your bicycle for a period of 3 months or longer, ensure to charge your
battery at least every 3 months. Failure to do so may cause damage to the battery, and
a loss of capacity.
A good way to manage storage charging is to set calendar reminders in your computer
or mobile device.
Cleaning
A clean bike is a happy bike. The best way to clean a dirty bike is with a bucket of warm
soapy water. Avoid using a pressure washer.
NOTE: Do not directly spray water at any electrical component.
Preventative maintenance
Clean and inspect drivetrain for wear
• Chain
• Cassette
• Pulleys (mid drive idler, lower idler, derailleur pulleys)
• Chainring
• Drive Pinion
Check bolts and fasteners
• All standard bicycle fasteners: pivots,
stem, crank bolts, chainring bolts
• Motor mounts
• Torque sensor mount
• Battery grub screw
• Battery retaining pin
• Check Spoke Tension
• Inspect Brake Pads & Rotors
• Keep Charge Port Clean / Closed
21