Makita EB7660TH Instructions D'emploi page 15

Checking throttle valve
If the control cable is bent or caught, the throttle valve does not con-
tact with the idle adjusting screw, and it prevents the engine from
proper idling. In such a case, reposition the control cable to ensure
proper valve movement.
► 1. Throttle valve 2. Idling adjusting screw 3. Control cable
4. Throttle valve stopper
If the throttle valve does not touch the throttle valve stopper even you
pull the throttle trigger fully or if the throttle valve does not touch the
idling adjusting screw while idling, turn the cable adjusting bolt as
follows:
1. Loosen the fixing nut.
2. If the throttle valve does not touch the throttle valve stopper, turn
the cable adjusting bolt counterclockwise.
If the throttle valve does not touch the idling adjusting screw, turn the
cable adjusting bolt clockwise.
2
► 1. Fixing nut 2. Cable adjusting bolt
3. Tighten the fixing nut to fasten the cable adjusting bolt.
Cleaning carburetor cover
If the carburetor cover gets dirty and it is difficult to check the throttle
valve, clean the carburetor cover as follows:
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like for cleaning the carburetor cover. Otherwise it may be
tarnished.
1. Pass a slotted screwdriver through the hole on the engine cover.
Release the clamp of the carburetor cover.
1
3
2
4
1
15 ENGLISH
1
► 1. Carburetor cover
2. Clean the carburetor cover.
NOTICE:
Use wet clean cloth for cleaning the carburetor
cover.
3. Return the carburetor cover. Make sure the clamp of the carbure-
tor cover clicks when it is set in place.
Inspecting bolts, nuts and screws and other parts
Retighten loose bolts, nuts, etc.
Check for fuel and oil leakage.
Replace damaged parts with new ones for safety operation.
Cleaning engine, cooling air inlet
Keep engine clean by wiping down with a cloth rag.
Keep the cylinder fins free of dust or dirt. Dust or dirt adhering to the
fins may cause engine overheat and piston seizure.
Blowing air is taken in from the air inlet vent. When airflow drops
down during operation, stop engine and inspect the air inlet vent for
any blockages. Clean it if necessary. Such a blockage may cause
overheat and damage the engine.
Replacing gaskets and packings
Replace gaskets and packings if the engine is disassembled.
Any maintenance of adjustment work that is not included and
described in this manual is only to be performed by Authorized
Service Agent.
Storage
WARNING:
When draining the fuel, stop the engine and
wait for the engine to cool down. Failure to do so may cause
burns or fire.