Ten Haaft CARO Digital MA Manuel D'utilisation page 90

Software update - RS232 interface
The serial RS232 interface is used to connect the receiver to a computer. On our
website at www.ten-haaft.com you will fi nd programs to support this functionality.
You can download updates of the operating software and up-to-date channel lists
that may resolve technical problems or provide new functions or channels.
E
Never use any other software updates than those provided on our website at www.
ten-haaft.com The usage of any third-party software update or software not re-
leased for your system variant may cause damage to your satellite system and may
render your warranty invalid.
If you do not have access to fi rmware or channel list updates, please contact your
local service center or the ten Haaft® service department (see back of manual).
The connection of the receiver to a PC requires a serial cable with a 1:1 pin alloca-
tion, i. e. hard-wired pins. The PC-side of the cable must have a 9 or 25-pin D-SUB
connector, depending on the serial port of your PC. The receiver-side of the cable
requires a 9-pin D-SUB connector. Extension cables for mice are confi gured accor-
dingly and can hence be used.
The pins of the receiver port are assigned as follows:
1, 4, 6 - 9
2
3
5
All manuals and user guides at all-guides.com
not assigned
TXD
RXD
GND
90