Ten Haaft CARO Digital MA Manuel D'utilisation page 86

All manuals and user guides at all-guides.com
CI Common Interface
E
At the front of the device there are two slots for modules to decode encrypted
programs.
To prevent damage only modules with the „PC Card" logo must be inserted. Any
other modules may damage the receiver beyond repair. Do not use excessive force
to insert the modules. Rather pull the module back out of the slot and try inserting
it again. Ensure that you insert the module with the correct side up and correctly
inserted into the slot.
Smartcards are sometimes printed in a confusing way as they are often designed to
be used with other decoders. Most common-interface modules allow cards with the
golden contacts facing upward. Before inserting a smartcard into the common-in-
terface module, make sure that the usually gold-coloured contacts on the smartcard
are clean and free of dust.
If a decoder module has been correctly identifi ed, its name is displayed in the main
menu under „Encryption". When you select the entry for this module in the list and
press OK, a menu will be displayed based on the corresponding decoder module.
Please contact the module manufacturer in case of any questions concerning the
module. Note: Some modules only register completely and provide a menu system if
a valid smartcard is inserted.
The keys OK and EXIT are used to navigate within the manufacturer-specifi c menus.
If a menu does not respond to the OK or EXIT command, the dialog can be cancelled
by pressing MENU. The receiver then interrupts the connection to the module's
menu system.
Please note: Not all encryption systems are available to common-interface
modules yet. Please check with your pay-TV provider, if a matching module is
available. If there is no response on "OK" or "EXIT", you can force to terminate
the dialogue, by the button "MENU". The receiver stops the connection to the
module.
86