Ten Haaft CARO Digital MA Manuel D'utilisation page 73

All manuals and user guides at all-guides.com
Editing sender list
You can adjust the channel list of your receiver to your personal requirements.
We suggest to group the channels by the satellites as with the default channel
list.
Select the channel list editor within the option „Sort Channels" in the sub-menu
E
„Channel list" in the main menu. After completing your settings, exit the channel
list with EXIT. Confi rm the subsequent prompt with OK to save that channel list.
To change the entries, select an entry in the list by pressing OK. A menu with the
available options will appear. Select option „Block" in this menu if you wish to edit
a complete block of sequential channels.
The menu will then disappear and you will be prompted to highlight the end of the
block in the list. Select the last entry of the block and press OK. The menu with the
available options will then be displayed again.
The following functions are available within this menu:
Copy:
Copies the channel to a different position in the channel list. The existing entry in
the target position is overwritten.
Move:
Moves the entry to a different position. Note: Moving an entry upward will insert it
ahead of the target entry, moving it downward will insert it behind the target entry.
Delete:
Deletes a channel from the channel list. The entry in the list will be marked as un-
used. The numbering of the remaining channels will remain unchanged.
Cut:
Deletes a channel from the channel list. The subsequent entries are moved up to
fi ll the free position. Note: To help keep the channels grouped in blocks, all of the
channels move up together only as far as the next entry marked as „unused". If e.
g. the list is not occupied between entry 85 and entry 99, you may delete entry 57,
and only channels 57 to 84 will move up. The channels from 100 are not affected.
73