Black & Decker BC6BDWCA Manuel D'instructions page 5

Charging Using the Supplied Battery Clips
1. Insert the double barrel tip of the battery clamp cable into the double barrel tip of the battery charger cable
(male-to-female and female-to-male). Then plug the battery charger's power cord into an AC outlet. The
power LED will light blue to indicate that the charger is plugged in and ready.
Note:
If the Power LED does not come on, check connection with the AC outlet. Make sure the AC outlet is functional.
2. Connect the battery charger to the battery using the battery clamps, following the appropriate directions
in the "Preparing to Charge" section at the front of this manual.
3. When the unit is properly connected and charging, the battery charging LED ( ) will light yellow to indicate
the battery is charging.
Notes:
If the Charging LED did not come on, check the connection to the battery. If the clamps are properly connected, the battery may
be in fault condition. Manufacturer suggests to have the battery tested by a qualified battery service technician.
If the clamps are incorrectly connected with regard to polarity, the reverse polarity/fault LED ( ) will light. Unplug the charger;
then remove the clamps. Reconnect the clamps properly.
4. When the charging complete LED ( ) lights green, the battery is fully charged.
When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp
from battery terminal.
Charging Using the 12 Volt DC Accessory Plug
CAUTION – To reduce the risk of property damage: Make sure that the vehicle's accessory outlet is clean
and free of debris before connecting the unit.
1. Insert the double barrel tip of the 12 volt DC accessory plug cable into the double barrel tip of the battery
charger cable (male-to-female and female-to-male). Then plug the battery charger's power cord into an AC
outlet. The power LED will light blue to indicate that the charger is plugged in and ready.
Note:
If the Power LED does not come on, check connection with the AC outlet. Make sure the AC outlet is functional.
2. Insert the grooved tip of the 12 volt DC accessory plug into the vehicle's 12 volt DC accessory outlet. Rotate
the adapter slightly to make sure there is good contact.
3. When the unit is properly connected and charging, the battery charging LED ( ) will light to indicate the
battery is charging.
Notes:
If the Charging LED did not come on, check the connection to the vehicle' s DC accessory outlet. Rotate the adapter slightly to
make sure there is good contact. If it is properly connected, the battery may be in fault condition. Manufacturer suggests to have
the battery tested by a qualified battery service technician.
Some vehicles require that the ignition be turned to the ACC (accessory) position to activate the DC accessory outlet. If your
vehicle ignition is required to be turned to the ACC position, be sure all the vehicle accessories (i.e. heater, fan, radio, TV, lights...
etc) are turned off. If not turned off, the charger might not be able to charge the battery.
4. When the charging complete LED ( ) lights, the battery is fully charged.
When disconnecting charger, disconnect AC cord, and then remove the 12 volt DC accessory plug from the
vehicle accessory outlet.
TROUBLESHOOTING
Unit Not Charging
CARE AND MAINTENANCE
Cleaning and Storage
To reduce the risk of electric shock, unplug the battery charger from the outlet before attempting any
maintenance or cleaning. Turning off the controls will not reduce this risk.
• Store the unit in a clean, dry, cool place when not in use.
• Clean the unit casing and cords (as necessary) with a dry (or slightly damp) cloth. Ensure that unit is
completely disconnected from battery and power source before cleaning.
• To maintain the operating condition and maximize the life of the charger cords, always coil them loosely for
storage. Do not wrap them around the unit or crimp them with a tight band.
Fuse Replacement (12 Volt DC Charging Adapter)
1. Remove plug from accessory outlet. Remove the end cap by turning counter clockwise and lifting off.
2. Remove center pin and spring. Remove fuse.
BC6BDWCA_ManualENFR_031517.indd 8-9
All manuals and user guides at all-guides.com
• Check that the charger is properly connected to a
live 120 volt AC outlet.
• If the battery to be charged has fallen below 2 volts,
the battery cannot be recharged with this unit.
8
3. Replace fuse with same type and size fuse (8 amp).
4. Replace center pin and spring inside plug.
5. Replace end cap by turning clockwise.
ACCESSORIES
Recommended accessories for use with this unit may be available from the manufacturer. If you need assistance
regarding accessories, please contact the manufacturer at 1-877-571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at
1-877-571-2391.
ONE-YEAR LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1)
YEAR from the date of retail purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be
replaced or repaired in the following ways: (1) Return the product to the manufacturer for repair or replacement
at manufacturer's option. Proof of purchase may be required by manufacturer. (2) Return the product to the
retailer where product was purchased for an exchange (provided that the store is a participating retailer).
Returns to retailer should be made within the time period of the retailer's return policy for exchanges only
(usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their
specific return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects resulting from normal wear and
tear, accidents; damages sustained during shipping; alterations; unauthorized use or repair; neglect, misuse,
abuse; and failure to follow instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which
vary from state to state or province to province. This product is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days from purchase of the product to:
Baccus Global LLC, One City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432. Baccus Global
LLC, toll-free number: (877) 571-2391.
SPECIFICATIONS
Input: 120VAC, 60Hz, 1.6A
Output: 12VDC, 6A
Imported by Baccus Global LLC, One City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432
www.Baccusglobal.com 1-877-571-2391
9
3/16/2017 2:03:14 PM