Velleman CAMIP16 Guide D'installation Rapide page 9

6. Open Internet Explorer on the PC, and enter the IP address and port
number in the URL box to access the camera in the following format:
http://ipaddress:portnumber
Example:
http://192.168.2.1:88
7. For details on the configuration of your camera, refer to the full user
manual on the CD-ROM.
10. Configuration with EagleEyes Mobile App
The installation method below describes the setup with an iPhone
®
D-Link wireless router and modem. The installation procedure is similar for
®
iPad or Android™ devices. Refer to the full manual on the included CD-ROM
for more information.
10.1 Prerequisites
Before proceeding, check the following:
We recommend that you use your own ADSL or cable internet service
for easy network configuration.
Your camera is connected to your wireless router with an 8P8C network
cable, and it is powered on.
EagleEyes-Lite or EagleEyes-Plus is installed on your device.
If not, download it from your device's app store.
Note: EagleEyes HD for iPad does not support network configuration.
Please install EagleEyes-Lite or EagleEyes Plus on your iPad instead.
10.2 Preparing the Network Configuration
1. Connect your camera to your wireless router using an 8P8C network
cable (see "Overview" above).
2. Write down the IP address of your wireless router. You will need it
later. To find the IP address, proceed as follows:
3. Connect your mobile device to the wireless router that has the camera
connected.
4. Go to Settings > WiFi.
5. Press the ">" button to see the details of the selected wireless network.
The IP address is visible next to "Router".
(In the sample screen, the IP address is 192.168.2.1)
V. 01 – 13/06/2013
CAMIP16
9
®
with a
©Velleman nv