Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
Focal Length Selection and Focus
Adjustment
Notes:
We recommend adjusting the focal length and focus at an ambient
temperature between 0 and 40 °C.
Finish the adjustment as quickly as possible (max. 10 minutes) to
prevent that excess humidity builds up inside the camera, and the
desiccant absorbs too much moisture and is unable to keep the camera
dry.
Avoid adjusting in a high moisture environment. If this is not possible,
then finish the adjustment as quickly as possible.
To adjust focal length and focus, proceed as follows:
1.
Open the front cover [8] of the camera by rotating it counter-clockwise.
Inside the camera, you see two handles to adjust the focal length [9]
and focus [10].
2.
Loosen the screw of the handle, rotate to adjust, then tighten the screw
again.
3.
Find the fresh desiccant (incl.) and place it in the camera as shown in
the illustration [11].
4.
Immediately place back the front cover of the camera and turn it clock-
wise to fasten it.
Note: Make sure the front cover is fastened well to prevent moisture
from entering the camera.
5.
Slide the sun shield over the camera [12].
7.
Installing the microSD Card
Caution:
The data on the microSD card will be deleted after inserting the card
into the camera.
The camera does not support hot swapping. Insert or remove the card
with the power disconnected.
Insert the card into the camera as shown in the illustration [13]. It is
recommended to use tweezers for inserting or removing the card.
8.
Connections
Cable Overview
Refer to the illustrations on page 3 of this manual.
a
8P8C network cable: to connect the camera to the router/hub. For PoE
installation, use only CAT.5e or CAT.6 cables, according to the
IEEE802.3af standard.
b
alarm in (yellow): for external alarm connection
V. 01 – 13/06/2013
CAMIP16
7
©Velleman nv
Publicité
Table des Matières
