Getting Started; Contents Of Carton; Tools Required - livin flame Belfort Instructions De Montage Et Mode D'emploi

Getting started

- Remove the appliance from the box.
- Remove any packaging from the product.
- Place the packaging inside the box and either store or dispose of safely.

Contents of Carton

- Electric wall mount fireplace
- Wall fixing bracket
- Fixing screws and wall plugs
- Remote control
- Instruction Manual
- Imitation fire blocks
Helpful Advice Before Fitting
- Please retain all packaging until you have checked and counted all the parts and the contents of
the fixing pack against the parts list.
- Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect and to replace any part of the electrical system if necessary.
- Keep little children away before and during installation. Be aware that the little children do not
be in contact with the parts.
- The electric fireplace can be installed almost anywhere in your home. Please, read and follow the
instructions carefully by choosing a location. For the best result, install the electric fireplace not in
direct sunlight.

Tools required

- Magnetic Phillips Screw Driver
- Boormachine Rotary hammer
Installation
- It's recommended at least 2 or more people install the fireplace.
- Do not switch the appliance on until it properly installed as described in this manual.
- Please note that before the electric fireplace will be installed on the wall, care must be taken not
to damage concealed cables.
- The electric fireplace should be located close to a suitable mains socket to enable connection. The
electrical socket must be easily accessible to allow disconnection.
- A height of 600mm from bottom of heater to floor is recommended for optimum viewing of
fuel bed.
- Minimum distance:
Sides 200 mm
Floor 350 mm
Ceiling 200 mm
Wall 0 mm
- Choose a solid and plain wall and then stick the template on the position where you want to install
the fireplace. (Picture 2)
- Drill the marked position using a suitable sized drill bit for the chosen fixings. (Picture 3)
- Install the 2 top hanging swell plug into the wall and then install the 2 long screws. (Picture 4)
- Fix the lower support bracket on the heater. (Picture 5)
- Locate the heater onto the 2 top hanging swell plug and secure the lower support bracket using 2
long screws. (Picture 6)
- Remove the template paper.
- Put the log or pebble stones on the fuel bed.
- Select the right fascia and then Install it onto the fire as the picture.
- Lock the fascia bracket with 2 short screws by screw driver as the picture.
All manuals and user guides at all-guides.com
ENG-3
Picture 1