Getting Started; Contents Of Carton; Tools Required - livin flame Frankfurt Manuel De Montage Et Mode D'emploi

Getting started

- Remove the appliance from the box.
- Remove any packaging from the product.
- Place the packaging inside the box and either store or dispose of safely.

Contents of Carton

- Electric fireplace
- Fixing screws and side decorative brackets
- Remote control
- Instruction Manual
Helpful Advice Before Fitting
- Please retain all packaging until you have checked and counted all the parts and the contents of the fixing pack
against the parts list.
- Do not use this appliance if any part has been under water. Immediately call a qualified
- service technician to inspect and to replace any part of the electrical system if necessary.
- Keep little children away before and during installation. Be aware that the little children do not
- be in contact with the parts.
- The electric fireplace can be installed almost anywhere in your home. Please, read and follow the instructions
carefully by choosing a location. For the best result, install the electric fireplace not in direct sunlight.

Tools required

- Magnetic Phillips Screw Driver
Installation
- It's recommended at least 2 or more people install the fireplace.
- Do not switch the appliance on until it properly installed as described in this manual.
- Do not place the electric fire directly on carpets. This to avoid possible discolouring caused by
- the heat or blockage of air inlets.
- The electric fireplace should be located close to a suitable mains socket to enable connection. The electrical socket
must be easily accessible to allow disconnection.
Installation:
Attach the four screws to the side brackets to the stove . After attaching the side supports can the fire be placed from the
back of the fireplace . Fix the fire with four screws on the chimney.