Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance
Warning: Before any maintenance and/or cleaning the exterior of the fireplace, disconnect the unit from
the power supply and leave until cooled off.
Remote Handset Battery Replacement: Replace with two AAA batteries. Make sure the batteries are
installed correctly in the remote control.
Maintenance of Motors: The motors used on the fan and flame effect are pre-lubricated for extended
bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater unit
is recommended.
Resetting the Thermal Cutout Switch: The appliance is fitted with an Electronic Safety Control (E.S.). This is
a safety device, which switches off the fire if, for any reason, the appliance overheats, e.g. when covered. If
the heater stops operating whilst the flame effect continues normally, this indicates that the E.S. Control is
in operation. The E.S. Control can only be re-set after the appliance has cooled down, in order to re-set the
E.S. Control proceed as follows:
-
Switch off the appliance (Manual On/Off switch) and leave for approximately 10-15 minutes.
-
Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the power
supply is disconnected at the plug socket outlet whilst you do this.
-
Switch on appliance and the E.S. Control will re-set.
-
Ensure that the appliance is functioning correctly.
Cleaning the fireplace
You can clean the exterior of the fireplace with a soft, damp, lint-free cloth. Do not use cleaning or
polishing products. To remove fingerprints or other remarks on the front glass panel, use a soft, damp,
lint-free cloth with a good quality household glass cleaner. The front glass panel should always be
completely dried with a clean, lint-free cloth or paper towel.
Caution: Do not use abrasive cleaners on the glass panel. Do not spray liquids directly onto any surface of
the unit.
Warning: An authorized service representative should perform any other servicing.
Warranty
Your fireplace has two year warranty against manufacturing defect, beginning at the date of purchase.
In case of a problem, contact the store that it sold to you.
Warranty will be honored when you present a dated invoice and is strictly limited to recognized faulty part.
Installation costs cannot, under any circumstance, be reimbursed for damages.
The manufacturer can't be held responsible for direct or indirect defect consequences, either towards
person or property.
The warranty will be voided if the fireplace was misused or used for other purpose than what they were
built for. The warranty will also be voided in case of deterioration or accident that occur following neglect,
bad supervision or form altered parts.
Technical specifications
Voltage:
220V-240V~ 50Hz
Total Watts:
2000W
Dimensions:
512mm L x 125mm W x 410mm H
Weight:
6 kg
Handelmaatschappij Steffex BV Oostzeestraat 4 7202CM Zutphen The Netherlands
All manuals and user guides at all-guides.com
ENG-6
Publicité
Table des Matières
