AEG BL18S Notice Originale page 7

LIGHT INDICATORS
Continuous green
Flashing green
Continuous orange
Continuous red
Flashing orange
BATTERIES
New battery packs reach full capacity after 4 - 5 chargings and
dischargings. Battery packs which have not been used for
some time should be recharged before use.
CHARACTERISTICS
After inserting the battery into the reception of the charger the
battery will automatically be charged (green lamp is fl ashing).
When a hot or cold battery pack is inserted into the charger
(orange lamp is illuminated continuously), charging will begin
automatically once the battery reaches the correct charging
temperature (0°C...50°C).
Charging time varies depending on the battery temperature,
charge needed and the type of battery pack being charged.
As soon as charging is completed, the charger switches over to
"trickle" charge to maintain the full capacity (green control lamp
is illuminated continuously)
If the red lamp is lit, either the battery pack has not been fully
inserted or there is a fault in the battery or the charger. To
ensure your safety, immediately stop using the charger and the
battery pack and have them checked by an AEG Customer
Service Centre.
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance
with local, national and international provisions and regulations.
• The user can transport the batteries by road without further
requirements.
• Commercial transport of Lithium-Ion batteries by third parties
is subject to Dangerous Goods regulations. Transport
preparation and transport are exclusively to be carried out by
appropriately trained persons and the process has to be
accompanied by corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and
insulated to prevent short circuit.
• Ensure that battery pack is secured against movement within
packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
If the supply cord of this appliance is
damaged, it must only be replaced
by a repair shop appointed by the
manufacturer, because special
purpose tools are required
470 411 - BL18S.indd 7 470 411 - BL18S.indd 7
All manuals and user guides at all-guides.com
Standby / Charging is
complete
Charging
Battery or charger is too hot/
cold - charging will begin/
resume when battery or
charger reaches correct
charging temperature
Damaged or faulty battery
pack or charger
Evaluation
y
Use only AEG accessories and AEG spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service agents (see
our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the ten-digit No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
Do not burn used battery packs.
Never charge a damaged battery pack.
Replace with a new one.
Do not dispose electric tools, batteries/rechargeable
batteries together with household waste material.
Electric tools and batteries that have reached the
end of their life must be collected separately and
returned to an environmentally compatible recycling
facility.
Check with your local authority or retailer for
recycling advice and collection point.
This tool is only suitable for indoor use. Never
expose tool to rain.
Class II tool.
Time-lag fuse 2.0 A
T2.0A
European Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH 7
20.06.2020 18:15:19 20.06.2020 18:15:19