Thermostat Link Reset - GE RAK348R1 Manuel Du Propriétaire

Thermostat link reset.

If there is difficulty installing a receiver, perform the following:
1. Press the SW4-INSTALL button inside the thermostat. The "Install" icon will flash. You only
need to begin the installation session to perform this reset.
2. Press and hold the PB1-NETWORK button on the inside of the thermostat board for
approximately 2 seconds.
3. Press the SW4-INSTALL button to end the reset procedure.
No response is displayed. All previous installation records will be wiped from thermostat
memory. You can continue from this point with the installation procedure. The PB1-NETWORK
button will only reset the thermostat installation data base if the thermostat is already in an
Installation Session (SW4-INSTALL button has been pressed). Otherwise, the PB1-NETWORK
button will have no effect.
8