Troubleshooting Tips - GE RAK348R1 Manuel Du Propriétaire

Troubleshooting tips.

Problem
No display
System fan does not
come on properly
Fan runs continuously
Room temperature is
not correct
Compressor doesn't run
or turn on immediately
when changing function
or setting
displays on screen
Solution
Make sure batteries are fresh and installed correctly. See the "Batteries"
section in this manual.
Verify that wiring is correct.
Check Fan Auto setting. If set to Fan 1 or Fan 2 position, fan will run
continuously.
If a wired thermostat was removed, make sure that the hole in the wall
was sealed with nonflammable insulation or putty, or use a wall plate
obtained from a local hardware or home building store.
There is a protective time delay (approximately 3 minutes) to prevent
tripping of the compressor overload. For this reason, the unit may not
start normal cooling or heating for 3 minutes after it is turned back on.
Replace batteries with 4 fresh AA alkaline batteries.
11