Panasonic WV-CF284 Serie Mode D'emploi page 13

Models Cable type
RG-59/U (3C-2V)
RG-6/U (5C-2V)
WV-CF284/
CF294
RG-11/U (7C-2V)
RG-15/U (10C-2V)
WV-CF284T/
LAN cable, etc.
CF294T
<Connection for WV-CF284T/CF294T>
q As a video output cable, the LAN cable
(Category 5) or the like is used. Cut off
the end of wires.
Approx. 200 mm {7-7/8"}
To avoid short-circuiting faults, unused wire tips should
be wound with an insulation tape.
w Pass the wiring materials, processed as
per q, through the twisted pair wire
WV-CF284T/CF294T
WV-CF284T/CF294T
Extensible length
Approx. 250 m
{825 ft}
Approx. 500 m
{1 650 ft}
Approx. 600 m
{1 980 ft}
Approx. 800 m
{2 640 ft}
Approx. 100 m
{328 ft}
Approx.
8 mm {5/16"}
Passive receiver
LAN cable etc.
Active receiver
LAN cable etc.
Recommended models: Passive receiver *1 (manufactured by Vigitron, Inc.)
holes and connect them to the twisted
pair wire terminals (+) and (–).
Twisted pair wire terminal
(Wire size: AWG22 - 28, twisted
pair or single wire)
Important:
The recommended length of the cable is 100
m {328 ft} or less. Connect a passive receiv-
er to the receiving device such as a monitor.
If the effect of noise is high and the cable
length is 100 m {328 ft} or longer, connect
an active receiver.
The UTP type cable (Unshielded Twisted
Pair Wires) is more subject to noise than the
BNC cable because the cable is not shield-
ed. If high resolution or noise prevention is
required, purchase
CF294.
*1
Coaxial cable
*2
Coaxial cable
Active receiver *2 (manufactured by Vigitron, Inc.)
Twisted pair wire hole
WV-CF284 or
VCR, etc.
VCR, etc.
WV-
13