Switching Off The Device - Hama BASIC X5A Mode D'emploi

g
All manuals and user guides at all-guides.com
4.2.2 Shred paper and plastic cards
■ Insert the paper or the plastic card into the centre of the feed shaft
(3). The cutting rollers are switched on automatically.
■ Let go of the paper or plastic card. The device switches off automa-
tically after shredding is completed.
NOTE!
►
4.2.3 Reverse run mode
NOTE!
►
■ Slide the operating switch (5) to the "Rev" position. The rollers of
the paper cutting system rotate in the opposite direction.
■ Pull the paper up and out of the feed shaft (3).
■ To return the device to standby mode, set the operating switch (5)
back to AUTO.
4.2.4 Emptying the bin
■ When the cutting rollers are still, lift the document shredder attach-
ment (2). The built-in safety shut-off switch automatically switches
off the device.
■ Empty the bin.
■ Place the document shredder attachment (2) back on the waste
bin (1).

4.2.5 Switching off the device

■ Slide the operating switch (5) to the "Off" position.
10
Empty the bin frequently in order to prevent damage to the
device.
These modes serve to remove any blockages in the cutter
system.
Basic X5A