Stihl MS 201 T Notice D'emploi page 21

Holding the chain saw
Place the chain saw securely on the
N
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
Hold the control handle of the chain
N
saw firmly in the right hand
Support the right knee on the
N
carburetor cover
MS 201 T
Starting
With the right hand, pull the starter
N
grip slowly until you feel it engage –
and then give it a brisk strong pull –
simultaneously press down on the
handlebar – do not pull the starter
rope out all the way – risk of
breakage! Do not let the starter grip
snap back – guide it vertically back
into the housing so that the starter
rope can rewind properly
With a new engine or after a long period
of disuse, with machines without an
additional manual fuel pump, it may be
necessary to pull the starter rope several
times – to prime the fuel line.
Starting the chain saw
There must not be anyone within the
swivel range of the chain saw.
2
3
H
L
Push the hand guard (1) forwards –
N
the chain is blocked
Simultaneously press the throttle
N
trigger lockout (2) and throttle
trigger (3) – set master control
lever (4)
Position cold start l
If engine is cold (even if the engine
–
has stalled during opening of
throttle after starting)
Position warm start n
If engine is warm (once the engine
–
has been running for approx. one
minute)
English
1
4
19