Waeco MagicWatch MWE250 Instructions De Montage Et De Service page 36

MWE-250-3.book Seite 36 Dienstag, 28. März 2006 4:50 16
All manuals and user guides at all-guides.com
Installing MagicWatch
Note
Pull the socket connectors of the extension cables through the
cable sleeve before inserting the sleeve in the body work.
➤ Lay out the extension cables in the boot so that they cannot be damaged
under any circumstances (e.g. by flying grit).
➤ Carefully fasten the extension cables behind the bumper.
➤ Insert the sensor plugs into the sockets of the corresponding extension
cables (see fig. 15 A, page 8).
6.4 Fastening the control electronics
Note the following information when selecting a place to fit the control elec-
tronics:
Note the length of the sensor cables.
The control electronics may not be damaged if you have luggage or
objects in the boot.
➤ Fasten the control electronics to a suitable place in the boot.
The control electronics should not be exposed to any moisture.
Note
The extension cables are marked: L (left) and R (right).
This marking helps you connect them to the control electronics to
ensure that the display is correct. These markings can also be
found on the control electronics.
The polarity of the socket cannot be reversed: They can be only
be plugged into the connection in one way..
➤ Plug the sockets of the sensor cable into the connections on the control
electronics (see fig. 15 B, page 8).
Make sure the locking pin catches.
36
MagicWatch MWE250