Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.1AT ASSEMBLY STEP 1
3.1 AT
BOLT (A)
20 mm
ONLY
Qty: 6
MAIN FRAME BOOT
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
12
All manuals and user guides at all-guides.com
HARdWARE fOR STEP 1 :
SPRING WASHER (B)
8.2 mm
Qty: 6
RIGHT CONSOLE MAST
* This step is for 3.1AT models only.
A
Cut the yellow banding straps and lift the running
ARC WASHER (C)
deck upward to remove all contents from underneath
8.2 mm
the running deck.
Qty: 6
B
Open hardware for step 1.
C
Slide main frame boot up consoLe mast.
Pull Lead wire through right consoLe mast.
After pulling the Lead wire through the mast, the
top of the consoLe cabLe should be located at
the top of the mast. Detach and discard Lead wire.
LEAD WIRE
NOTE: Do not pinch console cable when placing
CONSOLE CABLE
the mast onto the main frame bracket.
Place right consoLe mast over main frame
D
bracket.
Attach consoLe mast to main frame
E
bracket using 3 boLts (a), 3 spring
washers (b) and 3 arc washers (c).
NOTE: Do not tighten bolts until step 3 is complete.
F
Repeat steps D–E to attach Left consoLe mast.
Publicité
Table des Matières
