Fitting Instructions - gdw 1618 Mode D'emploi

Ssangyong Actyon Sport
2006 - ....
Ref. 1618

Fitting instructions

1. Remove the spare wheel.
2. Insert the assembly pieces (1) in the chassis through the hole in the back of the chassis beams
above the provided drillings. Place the assembly plate (2) with points (A) and (B) against the
bottom of the chassis beam on the provided drillings. Insert the bolts and the washers without
tightening.
3. Place the tow bar with points (A) and (B) at the left against the bottom of the chassis beam on the
provided drillings (C) and (D), corresponding the side of the assembly plate (2). Insert the bolts
and the washers and do tighten everything firmly (see tension).
4. Assemble the flange ball together with socket plate holder and the security shackle, insert the bolts
and tighten everything firmly (see tension). Only use plate (3) to assemble the ball 50V and the
rockinger.
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.