Milwaukee 9081-20 Manuel De L'utilisateur page 5

All manuals and user guides at all-guides.com
WARNING!
Charge only MILWAUKEE 12, 14.4
and 18 Volt battery packs in
MILWAUKEE chargers. Other types
of batteries may explode causing
personal injury and damage.
Charge your battery pack before using your
tool for the first time and when your tool no
longer performs with the power and torque
needed for the job. Full loading capacity of
battery pack is only reached after
4 - 5 chargings. Never completely dis-
charge the battery pack. Standard charg-
ing time will vary according to the type of
charger you use. The charging time will
also vary depending on the supply voltage
and charge needed. For example, if your
battery pack does not require a full charge,
charging time will be less.
FOR SPECIFIC CHARGING INSTRUCTIONS,
PLEASE READ THE CHARGER INSTRUC-
TION SHEET SUPPLIED WITH YOUR
CHARGER.
Battery packs are affected by tempera-
ture. Your battery
perform best and have longest life if it is
charged when the temperature is between
60°-80°F (15°-27°C). Do not charge in tem-
peratures below 40°F (5°C) or above 105°F
(40°C). Under these conditions, capacity
will be reduced. See "Maintenance".
Removing Battery Pack from Tool
Push in the release buttons and remove
the battery pack.
CHARGING & USING BATTERY PACKS
pack will
Inserting Battery Pack into Tool
Battery pack can be inserted into the tool
in two ways.
1. For working in restricted spaces.
Insert the battery pack from the front
by pressing in the release buttons and
sliding battery pack into the body of
the tool (Fig. 1). Insert the battery pack
until clamp engages.
Fig. 1
2. For optimum weight distribution and
balance.
Insert the battery pack from the back
by pressing in the release buttons and
sliding the battery pack into the body
of the tool (Fig. 2). Insert the battery
pack until clamp engages.
Fig. 2
5