Maintenance And Trouble-Shooting; Maintenance; Trouble-Shooting - Ugin DUCAGEL Z1 Mode D'emploi

Instructions for use (rev 110121)

6. MAINTENANCE AND TROUBLE-SHOOTING

Before to carry out the maintenance work and/or cleaning:
- disconnect from the main power supply (switch OFF and unplug to mains socket),
- wait the cooling at room temperature after use (risk of burns and/or damage).

6.1. MAINTENANCE

Observe the following recommendations to ensure the longevity of the device:
- Clean the machine outside with a soft, dry cloth.
- Do not use abrasive, solvents or flammables products for cleaning (outside and inside).
- Periodically, clean the inside of the tank with water to remove any residue gel. If necessary, remove the
knife (warning: very sharp blades).

6.2. TROUBLE-SHOOTING

PROBLEM
Equipment does
not heat
If the problem persists, contact the after-sale service.
UGIN DENTAIRE
CAUSE
1. Program setting (temperature)
2. Resistance / electronic card
PROCEDURE TO BE FOLLOWED
- Check the program's parameters setting:
low and high stabilisation temperature
value (see chapter 5.1.2).
- Resistance or electronic card is defective
or improperly connected: contact the
after-sales service.
DUCAGEL Z1
22