Operation; Speakerphone Operation & Volume Control; Mute The Mouthpiece; Caller Id - Type I & Ii - Depaepe DECT Process Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before registering a handset to the base, the base should first be put into subscription mode, by pressing and
holding the
key for 5 seconds, the base IN USE/CHARGE LED flashing.
1)
Press SET/OK key, then press ▲ or ▼key to select REGISTRATION item.
2)
Press SET/OK key to enter.
3)
Press ▲ or ▼ key to select BASE names. (If the handset already has a registration to the base, there is a "+"
on the right side of the display, and you should choose another base number if you don't want to lose that
one)
4)
Press SET/OK key to confirm, the display shows PIN?, key in the 4 digit PIN code for the base (the default
PIN code is 0000)
5)
Press SET/OK key to confirm, and the display will flash "SEARCHING 1"(or 2,3,4)
If the base is not found, the handset will return to the previous registration state.
If have several handsets, repeat the above steps to register another handset, and the successfully registered
handset will displays HS2 or HS3 on the LCD according to the registration sequence.
NOTE: Press
key to page the handset when difficult to look for.

OPERATION

Speakerphone operation & volume control
Press
key once to obtain a dial tone, dial your number, when you hear the called party answers the
phone.
You can also answer an incoming call by pressing the
During hands-free mode, press ▲ or ▼ key to adjust the speaker volume. There are 6 levels for selection.
NOTE: If you press
there are 5 levels for selection.

Mute the mouthpiece

During a call, press SET/OK key once to mute the mouthpiece and "MUTE" will show on LCD. Press SET/OK
key again to get back to the call and the MUTE will disappear.
Caller ID – type I & II
TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
TYPE II
During the conversation, the phone number of the incoming call of the third party can be seen in the unit.
This function can be worked when the user applied the Telecom service.
Auto timer
The timer will start automatically after the telephone line is engaged.
Flash (R)
Press R/CLR key to reset the line without leaving the handset.
Pause
Press RD/P key will insert a time delay of 3.6 seconds in a dialing sequence.
key to use earpiece, you can press the ▲ or ▼ key to adjust the earpiece volume,
key once.
33

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

29052018

Table des Matières