Depaepe DECT Process Notice D'utilisation page 30

3) Press ▲ or ▼ key to select ON or OFF, press SET/OK key to confirm. Selection of OFF will turn the
alarm off, and the user is dropped back to the ALARM menu surface, selection of ON option will turn
the alarm on, then the user will be requested to set the alarm time.
4) After select ON, press SET/OK key to start the time settings of alarm, "12-00" displayed with "12" is
blinking.
5) Press ▲ or ▼ key to change the hours, press SET/OK key to confirm, use the same method to
select minutes, AM/PM.
6) After select the alarm time, press SET/OK key, the user will be presented with a further option to
select to ON or OFF to enable or disable the snooze function on the alarm.
7) Press SET/OK key to confirm your selection.
8) When the alarm is set, the
Startup alarm:

In idle state, the alarm will ring at very sharp time you have set.
Intermit alarm:

During the alarming, you can switch it off by pressing any key of the handset, or when a call comes, the
alarm will be intermitted too.
Close alarm:

Re-enter the alarm setting menu option and select OFF.
NOTE: 1. If the SNOOZE is set ON, the alarm will be repeated about every 5 minutes for about nine times,
with the alarm icon continuing to flash. During the alarming, press any key except
intermit alarming, and will begin to ring after 5 minutes.
2. If the SNOOZE is set OFF, the alarm will sound for 45 seconds once.
RING SETUP

The user is able to change the handset ringing on Internal calls and external calls. There are 10 ringer
melodies and 5 different volume levels can be set.
1) Press SET/OK key, then use ▲ or ▼ key to select RING SETUP item.
2) Press SET/OK key to enter.
3) Press ▲ or ▼ key to select the INT RING and EXT RING setup.
4) Press SET/OK key to confirm.
5) Press ▲ or ▼ key to select the MELODY and VOLUME setup.

1) Press SET/OK key to confirm.
2) Press ▲ or ▼ key to select desired melody, the corresponding melody sound can be heard with the selection.
3) Press SET/OK key to confirm your selection.
If select VOLUME,

4) Press SET/OK key to confirm.
5) Press ▲ or ▼ key to select desired ringer volume 1- 5, if you want to switch off, select VOLUME OFF.
6) Press SET/OK key to confirm your selection.
NOTE 1) If you select VOLUME OFF for INT RING, when internal call to this unit, it will not ring;
will appear on the top of the display.
If select MELODY,
30
key to