Franke MYTHOS FMY 839 HI 2.0 Manuel D'utilisation page 4

EN
technician. Before making
the electrical connection,
please read the section on
ELECTRICAL CONNECTION.
For appliances with a power
supply cable, the terminals or
section of wire between the
cable anchor point and the
terminals must be arranged in
such a way as to allow the live
wires to be pulled out before
the earth wire in the event of
the cable coming out of its
anchor.
The manufacturer will not
Z X
be liable for any damage
resulting from incorrect or
inadequate installation.
Check that the mains power
Z X
supply corresponds to
the one indicated on the
identification plate fixed to
the inside of the product.
Fixed electrical connections
Z X
must incorporate the cut-out
devices envisaged by current
regulations.
For class I appliances,
Z X
check that the domestic
FMY 839 HI 2.0
power supply guarantees an
adequate earthing system.
Connect the suction
Z X
hood to the flue using a
suitable pipe. Please refer
to the accessories to be
purchased, indicated in the
installation manual
(for circular pipes: minimum
diameter 120 mm). The
exhaust pipe must be as
short as possible.
Connect the product to the
Z X
mains using an omnipolar
switch.
The air venting regulations
Z X
must be complied with.
Never connect the suction
Z X
appliance to ducts carrying
combustion fumes (heaters,
fireplaces, etc..).
If the suction hood is used
Z X
alongside non-electrical
appliances (e.g. appliances
with gas burners), it is
necessary to guarantee a
sufficient level of ventilation
in the room, to prevent any
exhaust backflow. When
the cooking appliance is
used together with other
– 4 –