Service And Maintenance; Changing The Filter Element; Emptying The Dust Container; Accessories - Festool CTM 26 E Notice D'utilisation D'origine

The machine shall be stored indoors on­
ly.
► Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.

9 Service and maintenance

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing maintenance
work on the machine!
► All maintenance and repair work which re­
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Customer service and repair only through
manufacturer or service workshops: Please
find the nearest address at: www.festool.com/
service
EKAT
4
5
3
2
1
Only use original Festool spare parts! Order No.
at: www.festool.com/service
Damaged safety devices and components must
be repaired or replaced in a recognised special­
ist workshop, unless otherwise indicated in the
operating manual.
Observe the following instructions:
– The manufacturer or an instructed person
must perform a dust test at least once a
year to determine whether the filter is
damaged, the machine is sealed properly
and the monitoring features are functioning
correctly.
– Anything that cannot be cleaned must be
discarded in impermeable bags. Observe
applicable disposal regulations!
– For user servicing, the machine must be
dismantled, cleaned and serviced, as far as
is reasonably practicable, without causing
risk to the maintenance staff and others.
Suitable precautions include, decontamina­
tion before dismantling, provision from lo­
cal filtered exhaust ventilation where the
All manuals and user guides at all-guides.com
machine is dismantled, cleaning of the
maintenance area and suitable personal
protection.
9.1

Changing the filter element

NOTE
Motor damage
► Never operate the extractor without a filter
element fitted as the motor may become
damaged.
► Open the locking clips [2-2] and remove the
top section of the machine[2-1].
► Turn the top section of the machine so that
the main filter is facing upwards (Fig.[9]).
► Fold over the lever [9-3] and remove the re­
tainer. [9-2]
► Remove the used main filter and replace
[9-1] with a new one.
► Dispose of the used filter in accordance
with statutory regulations.
► Insert the retainer [9-2] and fold over the
lever [9-3] until it engages.
► Replace the top section [2-1] and close the
locking clips [2-2].
9.2

Emptying the dust container

The dust container [2-3] can be emptied once
the top section has been removed.
► After extracting fluids, clean the fill level
sensors [10-1] regularly with a soft cloth
and inspect for damage.

10 Accessories

The order numbers for the accessories and fil­
ters can be found in the Festool catalogue or on
the Internet at "www.festool.com".
10.1 Modules
The following modules for upgrading the mobile
dust extractor are available in the accessories
programme. Modules must be fitted to the
module slot [1-3] by an authorised service
workshop:
– Compressed air module,
– Socket module with permanent power sup­
ply,
– Socket module with automatic switch-on
unit (not suitable for GB 110 V version),
– Energy box module (EAA) for using the au­
tomatic switch-on unit on the EAA.
You can find more detailed information on the
modules at "www.festool.com".
English
19