After Finishing Work; Service And Maintenance - Festool CLEANTEX CTM 26 E Notice D'utilisation D'origine/Liste De Pièces De Rechange

Remember: A moist main filter clogs more
quickly when extracting
Therefore, dry the main filter before extract-
ing dust or replace the damp filter with a dry
one.
8.5 Extracting fluids
Before extracting fluids, remove the filter or
disposal bag (see chapter 7.7). We recom-
mend using a special wet filter.
The dust extractor stops automatically when
the maximum level is reached.
CAUTION
Escaping foam and fluids
X Switch off the machine immediately and
empty the dirt trap.
8.6 The antistatic system
Friction inside the extraction hose causes
static electricity to develop during extraction.
Operating personnel may receive unpleasant
electric shocks while working. The mobile
dust extractor is fitted with an antistatic sys-
tem as standard to discharge any static elec-
tricity that may develop. However, always
use the enclosed antistatic extraction hose.
8.7

After finishing work

X
Only versions with AutoClean: Clean
the main filter automatically or manually
(see chapter 8.2).
X Switch off the mobile dust extractor and
disconnect the plug.
X Wind up the mains power cable.
X
Empty the dust container.
X Close off the extractor opening
ing the sealing plug [1-1].
WARNING
Hazardous dust
Damage to the respiratory passage
X Wipe down the mobile dust extractor and
clean all accessories thoroughly using the
extractor (inside and out) before removing
from the working area.
X Parts that you were not able to clean thor-
oughly must be sealed in an airtight plastic
bag prior to transportation.
X Wear a dust mask!
dry materials.
X
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indi-
cated in the operating manual.
Observe the following instructions:
– A dust test must be performed at least
– During maintenance and repair work, all
[1-2] us-
– For user servicing, the machine must be
CTM/ CTM AC CLEANTEX
The machine shall be stored indoors
only.
Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.
9

Service and maintenance

WARNING
Risk of injury, electric shock
X Always disconnect the mains plug from the
socket before performing maintenance
work on the machine!
X All maintenance and repair work which re-
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
once a year by the manufacturer or an in-
structed person. This test may include
checks to determine whether the filter is
damaged, the machine is sealed properly
and the monitoring features are function-
ing correctly.
components that cannot be cleaned satis-
factorily must be replaced. The old compo-
nents must be sealed in impermeable
plastic bags prior to disposal in compliance
with applicable regulations for this type of
waste.
dismantled, cleaned and serviced, as far as
is reasonably practicable, without causing
risk to the maintenance staff and others.
Suitable precautions include, decontami-
nation before dismantling, provision from
local filtered exhaust ventilation where the
machine is dismantled, cleaning of the
maintenance area and suitable personal
protection.
GB
19