Spray Gun; Nozzles - Generac Small Pro Manuel Du Propriétaire

General Information and Setup
4. See Figure 2-15
high-pressure hose to base of spray gun.
Hand-tighten for threaded connection.
Figure 2-15. Connect High-Pressure Hose
to Spray Gun - Quick Connect
Figure 2-16. Connect High-Pressure Hose
to Spray Gun - Threaded Connection

Spray Gun

Become familiar with spray gun trigger and
locking system prior to use.
1. See Figure 2-17. With unit OFF, hold spray
gun and squeeze trigger to learn how
trigger mechanism and locking system can
be activated and deactivated.
Figure 2-17. Spray Gun (typical)
2. Turn ON the water, and squeeze the
trigger to purge the pump system of air.
3. Verify spray gun is OFF with lock engaged
before starting power washer.

Nozzles

1. See nozzle selection guide and select
correct nozzle for task.
2. See Figure 2-18. Pull back quick–connect
collar and install nozzle.
6
and Figure 2-16. Connect
000269
000122
000123
Figure 2-18. Insert Nozzle
3. Release quick-connect collar to secure
nozzle.
4. Verify nozzle is locked in place.
Blast Pressure Nozzle (Red)
MAXIMUM - Higher pressure and lower flow
for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil
stains, rust removal
substances (tar, gum, grease, wax, etc.).
Strip Pressure Nozzle (Yellow)
MEDIUM - Higher pressure and medium flow
for removing stains on hard porous surfaces
such as concrete driveways, garage floors
and brick patios.
Clean Pressure Nozzle (Green)
GENERAL - Medium pressure and medium
flow for most all purpose cleaning such as
home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc.
Wash Pressure Nozzle (White)
DELICATE - Lower pressure and higher flow
for gentle cleaning of cars/trucks, boats, RV's,
patio furniture, lawn equipment, etc.
Owner's Manual for Power Washer
000125
or other stubborn
001396
001397
001398
001399