Safety Instructions; Work Area Safety; Electrical Safety; Personal Safety - Haussmann PT110636 Guide De L'utilisateur

All manuals and user guides at all-guides.com

SAFETY INSTRUCTIONS

WARNING!
! Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury.

1. Work area safety

a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmospheres, such as in the
c) Keep children and bystanders away while operating a power tool.

2. Electrical safety

a) Double insulated tools are equipped with a polarized plug (one blade is
b) Do not expose power tools to rain or wet conditions. Water entering a
c) Handle the cord carefully. Never use the cord for carrying, pulling or
d) If operating a power tool in a damp location is unavoidable, use a
e) When operating a power tool outside, use an outdoor extension cord
f) Do not use the equipment close to flammable objects.

3. Personal safety

a) Stay alert, watch what you are doing and use common sense when
b) Use personal protective equipment. Always wear eye protection.
c) Prevent unintentional starting. Ensure the switch is in the off-position
presence of flammable liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
Distractions can cause you to lose control.
wider than the other.) This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install a polarized outlet. Do not
change the plug in any way. Double insulation eliminates the need for the
three-wired grounded power cord and grounded power supply system.
power tool will increase the risk of electric shock.
unplugging the power tool. Keep cord away from heat, oil, sharp edges
and moving parts. Damaged or entangled cords increase the risk of electric
shock.
Ground Fault Circuit Interuptor (GFCI) protected supply.
Use of a CGFI device reduces the risk of electric shock.
marked "W-A"or "W". These cords are rated for outdoor use and reduce the
risk of electric shock.
operating a power tool. Do not use a power tool while you are tired or
under the influence of drugs, alcohol or medication. A moment of
inattention while operating power tools may result in serious personal injury.
Protective equipment such as dust mask, non-skid safety shoes, hard hat, or
hearing protection used for appropriate conditions will reduce the risk of personal
injuries.
before connecting to power source, picking up or carrying the tool.
Carrying power tools with your finger on the switch or plugging power tools
that have the switch on increases the risk of accidents.
15