Operation; Switching On And Off - Haussmann PT110636 Guide De L'utilisateur

OPERATION

WARNING ! Always use the correct voltage: The voltage of the power
source must match with the values on the nameplate of the power tool.

Switching On and Off

Note: Please refer to the graphic page on page 1 for tool part reference numbers
indicated below.
To start the power tool, push the ON/Off switch (2).
To lock the ON/Off switch, keep it pressed and additionally push the lock-on
button (1).
To switch off the power tool, release the On/Off switch (2). When the On/Off
switch (1) is locked, press it first and then release the On/Off switch (2).
WARNING ! Wait until the power tool has come to a complete stop
before placing it down.
Sanding Surfaces
Switch the power tool on, place it with the complete sanding surface on the
surface to be worked and move the power tool with moderate pressure over the
workpiece.
The removal capacity and the sanding pattern are mainly determined by the
selection of the sanding sheet, and the applied pressure.
Only flawless sanding sheets achieve good sanding capacity and extend the
service life of the power tool.
Pay attention to apply uniform sanding pressure; Intensifying the sanding
pressure does not increase the sanding performance. It causes an increase in
the wear of the tool and sanding sheet.
Intensifying the sanding pressure does not increase the sanding performance. It
causes an increase in the wear of the tool and sanding sheet.
A sanding sheet that has been used for metal should not be used for other
materials.
Use only original sanding accessories.
20
All manuals and user guides at all-guides.com
!
!