Haussmann PT110636 Guide De L'utilisateur page 20

All manuals and user guides at all-guides.com
ASSEMBLY
WARNING! Do not use the same sanding sheet for wood and metal.
!
Metal particles become embedded in the sandpaper and will scour a wooden
surface.
FITTING THE SANDPAPER
Your sander uses 1/3 sheet sandpaper, or pre-cut punched nylon backed sheets.
1) Using the clamp system
Note: Please refer to the graphic page on page 1 for tool part reference numbers
indicated below.
To fit the sand paper, proceed as follows:
Disconnect the plug from the electricity supply.
Press the handles of the front and rear paper clamp (5) upwards, to release them
from their retaining grooves.
Align the holes in the sandpaper (6) with the dust extraction holes in the base of
your sander.Use the punch plate to make holes in the sandpaper if none are
provided.
Hold the sandpaper in position and insert the edge of the sandpaper under the
front paper clamp. Press the handle of the paper clamp downwards and locate it in
the retaining groove. Keeping a slight tension on the sandpaper, to adhere it to the
base, insert the rear edge in the rear paper clamp. Press the handle of the paper
clamp downwards and locate it in the retaining groove.
Punch plate
After the paper has been installed, it will be necessary to punch holes into the
paper using the punch plate provided with your sander. Align sander base with
punch plate and push down on sander until punch plate pierces the paper. Then
remove punch plate from sander (see below)
2) Sanding sheets with loops and hooks:
Fix one side of the sandpaper, flush with one side of the backing pad (6)
Then attach the sandpaper to the backing pad (6) and press it firmly into place.
CONNECT THE DUST BOX
To connect the dust box, push it onto the rear of the sander until it locks in place.
To disconnect the dust box, press the dust box release button (4) and pull it off of
the rear of the sander.
19