2.3
Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a cordless electro-hydraulic crimping tool.
It is designed for crimping fittings used to connect composite, copper (Cu) and steel pipes.
•
Use only Hilti lithiumion batteries of the B 22 series with this product.
Use only Hilti-approved battery chargers to charge these batteries. More information is available from
•
your Hilti Store or from www.hilti.group
3.3
Possible misuse
•
Do not use this hand-held product clamped in a fixed position or as a stationary device.
•
This electro-hydraulic crimping tool may not be exposed to heavy rain or used under water.
3.4
Lithiumion battery status display
The charge state of the Li-ion battery and malfunctions of the product are indicated by the indicator of the
Liion battery. The state of charge of the Liion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED flashes.
*2188464*
1
2188464
Crimping / pressing head
@
Piston return switch to open the crimping /
;
pressing jaws in the event of a fault or emer-
gency
Casing
=
Servicing and fault indicator (red LED)
%
Battery release button
&
Battery
(
Slot on both sides to fasten the Hilti retaining
)
leash
White LED to illuminate the working area
+
Control switch
§
Locking pin for opening/closing the tool head
/
Crimping / pressing jaws
:
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
English
15