Control Knobs; Oven Vent; Control Panel; Care And Cleaning - GE ECBP82 Manuel Du Propriétaire

Care and cleaning of the range.
Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
24
WARNING:
reason, be sure the anti-tip device is re-engaged properly when the range is
replaced. Failure to take this precaution could result in tipping of the range and
cause injury.
How to Remove Protective Shipping Film and Packaging Tape
Carefully grasp a corner of the protective
shipping film with your fingers and slowly
peel it from the appliance surface. Do not
use any sharp items to remove the film.
Remove all of the film before using the
appliance for the first time.

Control Knobs

The control knobs may be removed for easier
cleaning.
Make sure the knobs are in the OFF
positions and pull them straight off the
stems for cleaning.

Oven Vent

The oven vent is located above the right rear
surface unit.
This area could become hot during
oven use.

Control Panel

It's a good idea to wipe the control panel
after each use of the oven. Use a damp
cloth to clean or rinse. For cleaning, use
mild soap and water or a 50/50 solution
of vinegar and water. For rinsing, use
clean water. Polish dry with a soft cloth.
If your range is removed for cleaning, servicing or any
To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive from packaging tape on new
appliances is an application of a household
liquid dishwashing detergent. Apply with
a soft cloth and allow to soak.
NOTE: The adhesive must be removed from all
parts. It cannot be removed if it is baked on.
The knobs can be cleaned in a
dishwasher or they may also be washed
with soap and water. Make sure the insides
of the knobs are dry before replacing.
Replace the knobs in the OFF position
to ensure proper placement.
It is normal for steam to come out of
the vent.
The vent is important for proper air circulation.
Never block this vent.
Do not use abrasive cleansers, strong
liquid cleaners, plastic scouring pads or
oven cleaners on the control panel—
they will damage the finish.