JVC KD-DV6101 Manuel D'instructions page 57

About sounds reproduced through the rear terminals
• Through the analog terminals (Speaker out/LINE OUT/2nd AUDIO OUT): 2-channel signal is
emitted.
When playing a multi-channel encoded disc, multi-channel signals are downmixed.
(AUDIO—DOWN MIX: see page 31.)
• Through DIGITAL OUT (optical):
Digital signals (Linear PCM, Dolby Digital, DTS, MPEG Audio) are emitted through this
terminal. (For more details, see below.)
To reproduce multi-channel sounds such as Dolby Digital and DTS, connect an amplifier or
a decoder compatible with these multi-channel sources to this terminal, and set "DIGITAL
AUDIO OUTPUT" correctly. (See page 31.)
• About Dual Zone
While you are listening to the radio, CD changer, or external component through the speakers
built into your car compartment, you can listen to the playback sound of this DVD/CD player
using the headphones connected to the 2nd AUDIO OUT plug at the same time. (For details,
see page 35.)
Output signals through the DIGITAL OUT terminal
Output signals are different depending on the "DIGITAL AUDIO OUTPUT" setting on the setup
menu (see page 31).
DIGITAL AUDIO OUTPUT
Playback Disc
DVD 48 kHz, 16/20/24 bits Linear PCM
96 kHz, Linear PCM
with DTS
with Dolby Digital
with MPEG Audio
Audio CD, Video CD
Audio CD with DTS
MP3/WMA
Output Signals
STREAM/PCM DOLBY DIGITAL/PCM
48 kHz, 16 bits stereo Linear PCM
DTS bitstream 48 kHz, 16 bits stereo Linear PCM
Dolby Digital bitstream
MPEG bitstream
44.1 kHz, 16 bits stereo Linear PCM /
48 kHz, 16 bits stereo Linear PCM
DTS bitstream 44.1 kHz, 16 bits stereo Linear PCM
32/44.1/48 kHz, 16 bits Linear PCM
PCM ONLY
48 kHz, 16 bits
stereo Linear PCM
48 kHz, 16 bits Linear PCM
57