Before Using For The First Time; Water Connection; Electrical Connection - Thermador T18IF900SP Guide D'utilisation Et D'entretien

en-us Installation and connection

Before using for the first time

Remove information material, adhesive tape and
1.
protective foil.
Clean the appliance.
2.
~ "Cleaning" on page 23

Water connection

9
CAUTION!
Installation and connection of the appliance
■
must be carried out by authorized technicians
according to the installation instructions
supplied.
To avoid damage to the appliance and to
■
ensure its proper functioning, it should only be
connected to a drinking water system.
To avoid water damage, a shut-off valve must
■
be installed.
Water pressure of drinking water system
9
CAUTION!
To avoid damage to the appliance, a pressure
relief valve must be installed between the
drinking water connection and the tubing,
should the water pressure exceed the
maximum value.
Note: If the water pressure is too low, this will impair
the relevant functions of the appliance.
Min. 0.2 Mpa (2 bar / 29 psi)
■
Max. 0.8 Mpa (8 bar / 116 psi)
■
8
All manuals and user guides at all-guides.com

Electrical connection

9
Note: You can connect the appliance to mains-
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national
grid. Sine-controlled inverters must be used for
isolated applications. Isolated applications, e.g. on
ships or in mountain lodges, are not directly
connected to the national grid.
1.
2.
3.
CAUTION!
Do not connect the appliance to electronic
energy saver plugs.
After installing the appliance, wait at least 1 hour
before connecting it to prevent damaging the
compressor.
Connect the appliance via a correctly installed
outlet.
9
WARNING
RISK OF ELECTRIC SHOCK!
The appliance must be properly grounded.
Never cut through or remove the third
(ground) conductor of the power cord.
Never use adapters.
Never use extension leads.
Requirements for outlets
Outlet with
Protective conductor
Fuse
Maximum simultaneous load
Appliance
Connect the appliance to a outlet near the
appliance.
The outlet must be freely accessible even after
the appliance has been installed.
110 V ... 120 V
60 Hz
10 A ... 16 A
6 A