Connecting The Water Heater To The Electricity - Atlantic CHAUFFEO VS 500L Notice D'installation Et D'utilisation

All manuals and user guides at all-guides.com

Connecting the water heater to the electricity

SWITCH OFF
THE ELECTRICITY!
Check the compatibility of the water heater with the electrical
installation.
The use of a rigid cable connection with a minimum cross-
phase (3 phases + earth) is essential (refer to the «wiring
diagram» section).
Check that the water heater is full by turning on a HOT water
tap. COLD water should
switched on when it is empty, there is a risk of damage (not
covered by the warranty).
Switch the electricity back on.
the thermostat) is strictly forbidden as it is extremely
dangerous, the water temperature would not be limited.
switch (reduced night tariff), move it to 1 (forced operation)
There may be some light smoke when heating starts
(NORMAL operation).
the safety unit (connected to a waste water drain pipe).
the water heater can emit a sound similar to that made by
a kettle.
This sound is normal and does not mean there is a fault.
Wait for heating to nish before using your water heater fully
(see speci cations table to determine the estimated time
depending on your model).
28
ow out. If the water heater is
1
AUTO
0
NO
Outlet
YES
cable
Hot Cold
water
water
1
AUTO
0
1
MAXI 2
3
4
8
7 5
6
Heating
time
MAX = 8 hours