Lincar Milly Instructions page 62

Pellet tank
Safety
temperature
Thermal
too high
Feeler
Exhaust feeler
Exhaust
signaling error
Fume
Hot
temperature too
Exhaust
high
A black-out
has happened
Black-Out
during the
regular
working.
Triac Co
Error Card Triac
Every intervention has be done from qualify staff !
Disconnect the equipment from electrical system before every maintenance operation
Every repairs must be done by our authorized assistance centre.
CORISIT S.r.l. is not responsible for damages to thing or people due to a wrong installation,
equipment tampering, improper use, bad maintenance or no observation of normative in
force. If considerate appropriate, CORISIT S.r.l. reserves the right to make modifications
without notice and in every moment.
Some particulars and accessories illustrated in this handbook are not mass produced item so
its extra costs are to check at contract release.
Up and frontal exhaust air
are obstructed
Temperature thermostat is
broken
Convection motor is
broken
Wrong appliance
carburation.
Change fuel.
Fume feeler
-----------------
-----------------
62/124
IT IT IT IT- - - - GB GB- - - - FR FR- - - - ES ES mod. 515SC
GB GB FR FR ES ES
Checking the up and frontal exhaust
air
To substitute thermostat
Checking the convection motor
Verify/replace exhaust feeler.
Verification of appliance by a
technical service center.
Proceed with "Pellet Correct".
Verification of appliance by a
technical service center.
Utilize better quality of pellet .
Proceed with "Pellet Correct".
Verify fume feeler position.
Verify/replace fume feeler.
Empty and clean the burner basket
and then proceed with the lighting
phase.
Call for technical service
.