Ksenia ergo KSI2100000.300 Guide De Programmation page 19

To open the transparent front cover, please proceed as follows:
Insert a flat screwdriver in the
1
slot
SUGGESTION ABOUT THE USE OF THE CAPSENSE TECHNOLOGY
The Keypad you have purchased do not utilize mechnical buttons, but the modern
Capsense Technology. If you already have other devices with capacitive Keypads,
you won't have any issues in utilizating it and therefore do not need to continue
reading this text. If instead it's your first time, we inviteto follow a few small advices in
order to obtain rapidly the best performances from this Technology. Once powered,
the Keypad does a self-calibration to adapt its sensitivity to the existing Humidity and
Temperature conditions.
Important note - Please wait 10 to 15 seconds before touching any buttons.
In this stage, it's important that the keypad is positioned in its actual use conditions, for
example if you are using the desk-mount support, do not live it up-side down. Should
this happen, no worries, leave it with no touch for 10 seconds and it will go in self-
calibration again in order to assure a consistent sensitivity in the course of time.
Attention - Please avoid any contact with wet fingers!
Getting the button's position, just touch upon with your finger tips, no pressure needed.
If you believe that the sensitivity is too low, do not increase the finger's pressure, this
doesn't bring any benefit. In this case, it is enough to change the sensitivity setting,
available in 3 different levels, by selecting it from the keypad menù or by programming
the setting taking advantage of the basis software.
At last a small test/game - Insert your PIN, surf in the menù with the circular scroll, select
a menù (for example the one which allows to insert a phone number in the phone-
book and insert it by digiting on the keypad). After few minutes only you'll be surprised
about your confidence with the ergo Keypad!
DEFAULT INSTALLER'S PIN: 123456
DEFAULT USER'S PIN: 147258
All manuals and user guides at all-guides.com
OPEN TRANSPARENT COVER
(active only after the KP has benn assigned to the lares Control Panel)
Pull outward
2
ergo
19