Maintenance And Cleaning - Sunrise Medical Jay J3 Carbon Manuel D'utilisation

ENGLISH
MAINTENANCE
Sunrise recommends that all fasteners be checked for
wear, such as loose bolts or broken components every 6
months. Loose fasteners should be retightened according
to the installation instructions. All fasteners should be
tightened to torque specifications as stated in the hardware
installation section. Contact your authorized Sunrise
Medical supplier immediately to replace any broken
components. Do not continue to use the system after
identifying loose or broken components.
EASY CLEANING
When disassembling the back for cleaning, note the
NOTE:
position of the Velcro® Spine Align Components for correct
reassembly.
To clean back cover
Remove cover by detaching Velcro. Detach cover from
back shell. Locate zipper on bottom of the cover and unzip.
Remove foam and turn cover inside out. Zip cover closed
to avoid snagging. Machine wash in warm water (60°C).
Drip or tumble dry on low heat.
Do not dry clean covers or use industrial washers
NOTE:
and dryers to clean cover. Do not steam autoclave. Do not
bleach.
Reinsert the foam into the cover. Please note, the base
has two layers of foam. When reinserting the foam, ensure
that the thinner "light grey" foam is facing the shell. Once
the foam is secured inside the cover, zip cover closed.
To clean back shell
Shell may be wiped clean with soap and water. No other
maintenance should be required.
To clean positioning components
Positioning components can be wiped clean with soap and
water. Do not immerse positioning components underwater.
If you have any additional questions regarding cleaning
procedures, please contact your authorized Sunrise
Medical dealer.
J3 Carbon Back 127048

MAINTENANCE AND CLEANING

Laundry Care Symbols
8
Machine wash in warm water
(60° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
US = Rev. A, EU = REV.1.0