Maintenance Intervals - Abicor Binzel BRS-LC Mode D'emploi

Station de nettoyage
Masquer les pouces Voir aussi pour BRS-LC:
Table des Matières

Publicité

BRS-LC

10.1 Maintenance intervals

NOTICE
• The maintenance intervals given are standard values and refer to single-shift operation.
The BRS-LC cleaning station is largely maintenance-free. However, it is necessary to regularly clean and evaluate the
mechanically stressed parts in order to maintain its value and to guarantee its full ability to function.
Check the following:
Weekly
• Check the condition of the reamer.
• Clean the clamping unit.
• Clean the injection unit.
• Dismount the cover of the injection unit and the thrust
ring and check the rubber seal.
 Fig. 9 Injection process on page EN-14
Tab. 13
Wartungsintervalle
11 Troubleshooting
DANGER
Risk of injury and machine damage when handled by unauthorized persons
Incorrect repair work and changes of the product may lead to significant injuries and machine damage. The product
warranty will be rendered invalid if the unit is handled by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
NOTICE
• If the measures described below are not successful, please consult your dealer or the manufacturer.
• Consult the documentation for the welding components.
11.1 Torch cleaning station BRS-LC
Fault
Cause
Compressed-air motor
• Compressed-air supply / hose connection
does not run
• Directional valves Y1 or Y2 do not switch
• Valve actuator does not move
Insufficient cleaning
• reamer defective or blunt
Torch parts are damaged
• Wrong or unsuitable equipment parts
Tab. 14
Troubleshooting of the BRS-LC
BAL.0030 • 2019-01-18
All manuals and user guides at all-guides.com
interrupted
Monthly
• ABICOR BINZEL recommends monthly basic cleaning
of the device.
Solution
• Check all supply lines leading to the cylinder and the
screwings
• Motor defective; replace
• Check signal output of robot control
• Replace directional valve
• Replace reamer
• Install a reamer and clamping prism that match the
gas nozzle
• Check the gas nozzle for deformations
• Check immersion depth of torch
11 Troubleshooting
EN - 19

Publicité

Chapitres

Table des Matières
loading

Table des Matières