Interfaces; Usb Interface; General Description; Interface Properties - Rohde ST 410 Notice D'utilisation

8.

Interfaces

8.1.

USB interface

8.1.1.

General description

The interface enables a USB flash drive to be connected to the controller. This is mainly used to generate files with a
timestamp and to store them on a computer for data logging. It can also read configuration and user-program data files into
the controller.
8.1.2.

Interface properties

• USB versions 1.0 or 2.0 are suitable for recording the measured values.
• USB 3.0 is not compatible.
• The USB flash drive must be formatted to FAT32 or FAT16.
• NTFS format is not suitable.
The data logger module has been tested with common USB flash drives of 8, 16 and 32 GB.
• The "USB flash drive plugged into USB port" indicator on the top of the housing confirms connection with a
compatible USB flash drive.
PROHIBITION
Do not connect any other devices, except a USB flash drive, to this USB interface.
⇒ No devices such as cell phones or laptops may be plugged into this USB interface to charge
8.1.3. Inserting & removing USB flash drives
• The USB port (1) for inserting the USB flash drive is located on the top of the
housing, under an easily removable cover (2).
• Keep the USB port cover attached and plug it in when not in use.
• The USB flash drive may only be plugged into the controller or removed
when no data is being written to it.
• To insert and remove a USB flash drive, the controller does not have to be
switched off.
• The "USB flash drive plugged into USB port" indicator (3) on the top of the
housing goes out as soon as the flash drive is removed.
8.1.4.

"Data transfer" indicator

Display
the battery.
Description
The "data transfer" indicator flashes when information is being written to the USB flash drive.
67 / 280