Rohde ST 410 Notice D'utilisation page 60

To be able to program a fan cooling system in the firing program, the additional switch output must first be set to "3" in the
parameter configuration (see Section 10./Parameter no. 45).
⇒ If parameter no. 45 has not been set to "3", the wrong configuration menu is displayed.
Note:
1. If no button is pressed for 30 seconds, the control automatically exits the cooling system temperature configuration
menu. Previous entries are not saved and will be lost.
2. The controller must not be running a program when programming the cooling system temperature ("Program running"
indicator must not light up).
3. In the sequence described, it is important that the
be saved.
Programming the cooling system using a fan in the configuration menu:
Step Display screen
1
FAn. 1
2
FAn. 1
3
410
4
411
5
411
6
FAn. O
7
630
8
632
9
632
10
g
Icon Description
The control unit must not run a firing
program during programming.
h
Press the and
to open the menu.
h
Release the
g
Press the key.
Enter the cooling system switch-on
temperature by pressing the
key.
g
Press the key to confirm the entry.
The menu for the cooling system switch-
off temperature is displayed.
g
Press the key.
Enter the cooling system switch-off
temperature by pressing the
key.
To complete the configuration, press the
g
key.
60 / 280
key is pressed a total of four times, otherwise, changes will not
g
keys simultaneously
g
and keys.
d f
or
d f
or
Remark
If necessary, stop the firing
j
program with the key.
The menu for the cooling system
switch-on temperature is
displayed.
The last set cooling system
switch-on temperature is
displayed.
The keys can also be held down
for faster input.
The last set cooling system
switch-off temperature is
displayed.
The keys can also be held down
for faster input.
The newly entered temperature
values are saved and the
previous entries are reset at the
same time.