Mounting; Mounting The Bracket; Connecting The Connection Cable; Control Unit Extension Cable - Rohde ST 410 Notice D'utilisation

4.

Mounting

4.1.

Mounting the bracket

• The control unit comes with a suitable mounting bracket which can be
attached to the kiln or at the operation location (near the kiln or on a wall).
• The bracket is attached with 2 screws.
• Note the direction of the arrow while the bracket is being installed
(arrow direction = up).
• Never place the control unit on the kiln but use the bracket instead.
• When mounting on the kiln, the bracket is mounted on a suitable controller
mounting plate or the switch box.
• Please refer to the operating instructions for the kiln.
• When mounting on a wall, the bracket is screwed directly to a wall near the
kiln using the fastening material supplied.
• The appropriate mounting material is included in the scope of delivery.
WARNING
An incorrectly placed control unit can lead to serious personal injury or property damage.
⇒ The control unit should never be placed on the kiln but should only be positioned in the
4.2.

Connecting the connection cable

Step Description
1 Insert the plug of the control unit into the socket on the kiln.
The plug and socket have a geometric coding – the plug and socket only fit
2
together in one position.
The wide lug on the plug must be at the top in the 12 o'clock position to fit
3
into the wide recess on the plug, also in the 12 o'clock position.
4 You may have to twist the plug a little until it clicks completely into the socket.
5 Tighten the outer screw ring on the plug clockwise.
4.3.

Control unit extension cable

• If the bracket for the control unit is attached at the operation location (near the kiln or mounted on a wall), the cable
can be extended using an extension cable.
• The extension cable for the control systems is optionally available in lengths of 2.5, 5 or a maximum of 10 meters.
• Note on extension cables and environmental influences due to EMC:
­
To meet the requirements for electromagnetic compatibility (EMC), the length of the controller connection
cable should not exceed 3 meters.
­
If the controller is connected to the kiln with an extension cable, it should be ensured that there is no electrical
device in the direct vicinity of the cable (electromagnetic stray field).
­
Otherwise, a loss of accuracy of up to 3°C could occur.
4.4.

Third-party kiln note

The wiring of the mating CPC 14 socket on the kiln can vary between kiln manufacturers!
bracket provided for it.
49 / 280