View Freeze Frame; O2 Sensor Test; On-Board Monitor Test; Evap System Test - Launch Creader V+ Manuel De L'utilisateur

LAUNCH
Creader V+ English User's Manual
Press [ ] to return to Diagnostic Menu.

4.2.5 View Freeze Frame

When an emission-related fault occurs, certain vehicle conditions are recorded
by the on-board computer. This information is referred to as freeze frame
data. Freeze Data is a snapshot of the operating conditions at the time of an
emission-related fault.
Note: if DTCs were erased, Freeze Data may not be stored in vehicle memory
depending on vehicle.

4.2.6 O2 sensor test

The results of O2 sensor test are not live values but instead the results of the
ECU's last O2 sensor test. For live O2 sensor readings, refer to any of the live
sensor screens such as Graph Screen.
Not all test values are applicable to all vehicles. Therefore, the list generated
will vary depending on vehicle. In addition, not all vehicles support the Oxygen
Sensors screen.

4.2.7 On-board monitor test

This function can be utilized to read the results of on-board diagnostic
monitoring tests for specific components/systems.

4.2.8 EVAP System Test

The EVAP test function lets you initiate a leak test for the vehicle's EVAP
system. The Creader V+ does not perform the leak test, but signals to
vehicle's on-board computer to initiate the test. Before using the system
test function, refer to the vehicle's service repair manual to determine the
procedures necessary to stop the test.

4.2.9 Vehicle Info

Select [Vehicle Info] and press [ ], the screen will display the information,
such as VIN (Vehicle identification Number), CID (Calibration ID) and CVN
(Calibration verification number).

4.3 DTC Lookup

Select [Code Lookup] in the Main Menu and press [ ] and the screen will
display the interface as shown below:
18