Valor Madrona MFCS05 Manuel D'installation page 6

20. Secure the bottom front of the engine and lower
bracket to the side panel stud.
21. Lift the partially assembled stove upright and place
the heat shield on top of the stove and secure it
with 2 screws at the front.
Optional Fan
22. If this installation requires the optional fan, install it
now at the back of the heater. Using the lower set
of fixing holes on the fan will ensure more space to
handle the receiver in front of the fireplace.
Rear view
Lower set of
fixing holes
6
Note: The top
spar supplied
with the engine is
not used with this
casing.
See 555CFK—Circulating
Fan Kit manual for com-
plete installation details.
23. Place the stove in its final position.
Top Panel and Vent Collar
24. Install the top cast panel on the stove locating its
"feet" within the casting sides.
25. Rear outlet only: Fit the cast cover into the opening
of the top panel.
Top outlet only: Place the vent collar on top of the
outlet to be fitted over the vent pipe when installed.
Rear outlet
Inlay Panels, Gas Supply Pipe and Access Door
26. Level the stove unscrewing the levelling bolts at the
four lower corners of the stove if necessary.
Note: If you are installing the stove in a mobile
home, remove the levelling bolts and use the holes
to secure the stove to the floor.
Top outlet