Husqvarna PG 830S Manuel D'utilisation page 9

Guide values for power source
Nominal Min. voltage at
voltage the product, V
from power
source, V
3x220 200
3x400/440/ 380
480
3x220 200
3x400/440/ 380
480
Grounded product instructions
WARNING: Incorrect connection can result
in electrical shock. Speak to an approved
electrician if you are not sure if the product
is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug is not correct for the mains outlet, let an
approved electrician install a correct mains
outlet. Obey local regulations and laws.
If you do not fully understand the
instructions about the grounded product,
speak to an approved electrician.
The product has a grounded power cord and power
plug. Always connect the product to a grounded mains
outlet. This decreases the risk of electrical shock if there
is a malfunction.
Do not use electrical adapters with the product.
Extension cables
• Use only approved extension cables with sufficient
length.
• The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
• Use grounded extension cables.
• When you operate the product outdoors, use an
extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
• Keep the connection to the extension cable dry and
off the ground.
• Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
• Make sure that the extension cable is in good
condition and not damaged.
8
Max. voltage at Frequency,
the product, V Hz
240 50/60
480 50/60
240 50/60
480 50/60
Nominal Motor out-
current, A put
50 11+1.5
30 11+1.5
50 11+1.5
30 15+1.5
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
• Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
Emergency stop button
The emergency stop button is used to quickly stop the
motor. The emergency stop button breaks the mains
power supply.
CAUTION: Do not use the emergency stop
button as the stop button for the product.
Min. cable Max. cable
area length m/ft
mm2/AWG
10/7 190/620
6/9 190/620
10/7 190/620
6/9 190/620
1253 - 003 - 22.01.2020